TSG-Terminal Working Group 1 #1	TSGT1#1(99)008
Nice 1 - 3 February 1999	

TSG-RAN Working Group 4 (Radio) meeting #1	TSGR4#1(99)018
Espoo 21st - 22nd January 1999	

Agenda Item:		6, Also TSG-T WG1 meeting #1

Source: 		Ericsson, Nokia

Title: 		Incorporation of material from ETSI and ARIB for 3GPP MS and BS radio requirements (FDD).

Document for:		Discussion

1.	Introduction

This document provides a proposal for the merging of existing Mobile Station and Base Station radio requirements specifications from ETSI and ARIB into draft 3GPP specifications. 
The existing specifications cannot be copied directly into 3GPP specifications, as structure of documents does not match and different specifications groups exist in 3GPP. The intention of this document is to aid the 3GPP TSG-RAN WG4 and 3GPP TSG-T WG1 to create a draft specification. Relations of referenced documents with other 3GPP TSG WGs are outside the scope of this document.
The structure of ETSI specifications is assumed as basis for 3GPP specifications[1][2}.
2.	Overview of relevant specifications

Table below gives an overview of relevant specifications that contain contents for the MS and BS radio requirements (FDD).
SDO	Document	Contents	
ETSI	XX.06 “UTRA FDD, Radio transmission and reception”, rev. yyyy,  Jan’98	Specifies the transceiver requirements, such as frequency bands, channel arrangement, transmitter and receiver characteristics, and reference performance. This document includes both Basestation and Mobile station aspects. 	
ARIB	Volume 4, (Draft) Specifications of Mobile Station for 3G Mobile System, Ver 1.0-1.0, Dec’98

Volume 5, (Draft) Specification of Base Station for 3G Mobile System, Ver 1.0-0.1, Jan ‘99	Specifies the transceiver requirements, such as frequency bands, channel arrangement, transmitter and receiver characteristics, and reference performance (mostly section 5). 
This document only specifies the Mobile station, but includes test conditions and measurement methods. 
As above, but for Base Station	
3GPP	TSG-RAN WG4: Radio transmission and reception (FDD)
	Specifies the transceiver requirements, such as frequency bands, channel arrangement, transmitter and receiver characteristics, and reference performance. This document includes both Basestation and Terminal aspects.	
3GPP	TSG-T WG1: Mobile Station (MS) conformance specification	Specifies the requirements for conformance testing of a Mobile Station including test conditions and measurement methods.	

3	Incorporations of contents from ETSI and ARIB 
3.1	ETSI XX.06 

Contents of ETSI XX.06 can be directly mapped to TSG-RAN WG 4 specifications for both MS and BS, if the structure of that document is adopted as the basis.
3.2	ARIB MS specifications

Table below shows how different relevant sections of ARIB Volume 4 can be used for  merging into 3GPP specifications by TSG-RAN WG1 & 4 and TSG-T WG1.
Section	Description	Incorporation, comment	
1-2	Introduction, General requirements	?	
3	EMC	3GPP MS EMC specifications (new item)	
4	Safety	?	
5.1	RF specifications
5.1.1 Transmitting characteristics
5.1.2 Receiving characteristics
“definition”
“minimum requirement”	TSG-RAN WG4: Radio transmission and reception (FDD)	
5.1	RF specifications
5.1.1 Transmitting characteristics
5.1.2 Receiving characteristics
“Test conditions and measurement method”	TSG-T WG1: Mobile Station (MS) conformance specification	
5.2	Signal transmission and reception	Mostly references to Vol.3 (L1). 
TSG-RAN WG1 (L1)	
5.3	Layer 1 procedures	Mostly references to Vol.3 (L1). 
TSG-RAN WG1 (L1)	
5.4
5.5	Performance requirements
Timing requirements
“General”
”Definition”
“Minimum requirements”	TSG-RAN WG4: Radio transmission and reception (FDD)	
5.4
5.5	Performance requirements
Timing requirements
“Test conditions and measurement method”	TSG-T WG1: Mobile Station (MS) conformance specification	
6 – 12	Not related to radio requirements	-	
13	Measurement procedures	TSG-T WG1: Mobile Station (MS) conformance specification?	

3.3	ARIB BS specifications

As the actual values for radio requirements of BS has not been specified in the specifications, it should be noted that the measurement methods described in the specifications should be restudied together with concrete values for requirements.  However, it is proposed that the items covered in Volume 5, e.g EMC etc., are to be taken into account when discussing additional items to be covered in the BS requirements in 3GPP..
References
[1]	3GPP/TSGR#1(98)-003, "Proposed specification structure for the Radio Access Network TSG", source Ericsson.
[2]	3GPP/TSGT#1(98)-027, “Proposed Specification Structure for the Terminals TSG”, source Ericsson.